Use and Care Manual

Assembly (continued)

10 Assembling the reector

□ Loosely screw the side panels (L) together using twelve

bolts (AA) and nuts (BB), overlapping as shown below.

□ Attach the top panel (K) to the top of the assembled side

panels (L) using six bolts (AA) and nuts (BB), and then

fully tighten all bolts.

WARNING: While every precaution has been made in the

manufacture of this product, care must be taken during

assembly in case sharp edges are present.

9 Fitting the reector handle

□ Using the pre-tted R-clip (1) and pin (2), secure the

reector handle (J) to the bracket as shown.