Installation Guide

Page 6
PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
3ea Wire Connectors (#25) 1ea Hex Nut (#26) 1ea Mounting Strap (#27)
1ea Ground Screw (#28) 1ea Nipple (#29) 2ea Outlet Box Screws (#30)
INSTALLATION INSTRUCTIONS:
1. Screw the Nipple (#29) a half-inch into the Mounting Strap (#27). Tighten the Hex Nut (#26)
against the Mounting Strap (#27) to secure the Nipple (#29). Attach the Mounting Strap (#27)
to the Outlet Box (#24) using the two Outlet Box Screws (#30). [Make sure the longer end
of the Nipple (#29) is facing outside when the Mounting Strap (#27) is attached to the Outlet
Box (#24).]
2. Adjust the Chain (#3) to required height by lifting the fixture and attaching the Quick Link
(#31) to the Loop (#5) and to a link of Chain (#3) closer to the ceiling. The fixture can be
raised and lowered in this manner until the desired height is achieved. Next, use pliers and a
screwdriver to twist open (cover the chain with cloth to prevent damage to the link finish)
the first unused link of Chain (#3). Remove and save the excess chain. Pull the excess
fixture wires through the Nipple (#29) into the Outlet Box (#24). Wires may be left at full
length or shortened as determined by space in the Outlet Box (#24) to make the wire
connections.
3. Wrap the ground wire from the fixture around the Ground Screw (#28) on the Mounting
Strap (#27), and then connect the ground wire from the fixture to the ground wire from the
Outlet Box (#24). Connect the wire without writing on it (with raised ribs) from the fixture
to the white wire (neutral wire) from the Outlet Box (#24). Connect the wire with writing on
it from the fixture to the black wire (live wire) from the Outlet Box (#24). Cover the three
connections using the three Wire Connectors (#25). Wrap the three wire connections with
electrical tape for a more secure connection. Position the wires back inside the Outlet Box
(#24). Note: If you have electrical questions, consult your local electrical code for approved
grounding methods.
4. Place the Canopy (#1) over the Nipple (#29) all the way to the ceiling. Tighten the Ring (#4)
onto the Screw Collar Loop (#2) until the Canopy (#1) is held firmly against the ceiling.
5. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the light
switch on to activate the fixture.