Installation Guide

Page 4

PARTS INCLUDED FOR ASSEMBLY (parts are not to scale):

1ea Canopy (#1) 1ea Screw Collar Loop (#2) 5 feet Chain (#3) 1ea Ring (#4) 1ea Loop (#5)

1ea Cover (#6) 1ea Sleeve (#7) 1ea Washer (#8) 1ea Nipple (#10) 6ea Side Screw (#13)

1ea Column (#11)

1ea Column A (#15)

1ea Finial (#18) 6ea Screw (#19) 1ea Hex Key (#20) 6ea Socket Sleeve (#22) 1ea Quick Link (#31)

ASSEMBLY INSTRUCTIONS:

1. Carefully unpack the fixture. Lay out all parts on a clean surface. Evenly spread the fixture

arms to open the chandelier (see Fixture Distribution on Page 5).

2. Screw the Column (#11) onto Nipple A (#12). Screw Column A (#15) onto Nipple B (#16).

Screw the Finial (#18) onto Nipple C (#17).

3. Align the six arms with the Sockets (#21) on them into an upright position. Secure them by

using the Hex Key (#20) to screw the six Screws (#19) into the six Bushings (#14).

4. Align the six arms of the Fixture Body (#9) with the six Bushings (#14). Secure the arms by

using a screwdriver to screw the six Side Screws (#13) into the six Bushings (#14).

Run

the fixture wires through the Fixture Body (#9), the Washer (#8), the Sleeve (#7), the

Cover (#6), and then the Loop (#5). Screw the Loop (#5) onto the Nipple (#10). Use the

Quick Link (#31) to attach the Chain (#3) to the Loop (#5).

6. Weave the fixture wires up through the Chain (#3), through the Ring (#4), through the Screw

Collar Loop (#2), through the Canopy (#1), and through the Nipple (#29 on Page 7) on the

Mounting Strap (#27 on Page 7). Screw the Nipple (#29) into the Screw Collar Loop (#2).

7. Place the six Socket Sleeves (#22) over the six Sockets (#21).

8. Install six 60 watt candelabra incandescent light Bulbs (#23) (not included) or six equivalent

candelabra

compact fluorescent light bulbs (not included) in the six Sockets (#21) in the

fixture.