Installation Guide

Page 19
AVERTISSEMENT:
1. Avant de commencer à installer ce luminaire ou d'enlever l'ancien luminaire,
déconnectez le courant en éteignant le disjoncteur ou en enlevant le fusible
correspondant du coffret à fusibles.
2.
CONSULTER UN ELECTRICIEN QUALIFIE POUR TOUTE QUESTION
RELATIVE A L'ELECTRICITE.
3.
En cas de questions non relatives à l'électricité à propos de ce luminaire,
veuillez contacter notre centre de Service à la Clientèle au 1-877-527-0313
ou visiter www.homedepot.com.
Veuillez indiquer votre UGS
401-415 ou UPC
6940500310510.
4.
Conserver votre reçu et ces Instructions comme Preuve d'Achat.
OUTILS REQUIS POUR L'ASSEMBLAGE & L'INSTALLATION
(non inclus):
Ampoule Lunettes de Protection Echelle Gants Dénudeur de Câbles Electriques
(60 watts maxima)
(ou équivalent LFC)
Tournevis à Tête Plate Tournevis à Croisillon Ruban Adhésif Isolant Pince pour Câbles Electriques
Page 6
PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
2ea Lock Nuts (#2) 3ea Wire Connectors (#8) 2ea Mounting Screws (#9)
1ea Mounting Strap (#10) 1ea Ground Screw (#11) 2ea Outlet Box Screws (#12)
INSTALLATION INSTRUCTIONS:
1. Screw the two Mounting Screws (#9) into the Mounting Strap (#10). Mount the
Mounting Strap (#10) to the Outlet Box (#7) using the two Outlet Box Screws (#12).
[Make sure the threads of the Mounting Screws (#9) are facing outside when the
Mounting Strap (#10) is attached to the Outlet Box (#7).]
2. Wrap the ground wire from the fixture around the Ground Screw (#11) on the Mounting
Strap (#10), and then connect the ground wire from the fixture to the ground wire from
the Outlet Box (#7). Connect the white wire from the fixture to the white wire (neutral
wire) from the Outlet Box (#7). Connect the black wire from the fixture to the black wire
(live wire) from the Outlet Box (#7). Cover the three connections using the three Wire
Connectors (#8). Wrap the three wire connections with electrical tape for a more secure
connection. Position the wires back inside the Outlet Box (#7). Note: If you have
electrical questions, consult your local electrical code for approved grounding methods.
3. Place the Canopy (#1) against the Outlet Box (#7) by aligning the protruding Mounting
Screws (#9) all the way through the holes on the Canopy (#1). Tighten the fixture to the
ceiling by screwing the two Lock Nuts (#2) onto the two protruding Mounting Screws
(#9).
4. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the
light switch on to activate the fixture.