Installation Guide

Page 19
AVERTISSEMENT:
1. Avant de commencer à installer ce luminaire ou d'enlever l'ancien luminaire,
déconnectez le courant en éteignant le disjoncteur ou en enlevant le fusible
correspondant du coffret à fusibles.
2. CONSULTER UN ELECTRICIEN QUALIFIE POUR TOUTE
QUESTION RELATIVE A L'ELECTRICITE.
3. En cas de questions non relatives à l'électricité à propos de ce luminaire,
veuillez contacter notre centre de Service à la Clientèle au 1-877-527-0313
ou visiter www.homedepot.com. Veuillez indiquer votre UGS 689-045 ou
UPC 7259168229203.
4. Conserver votre reçu et ces Instructions comme Preuve d'Achat.
OUTILS REQUIS POUR L'ASSEMBLAGE & L'INSTALLATION
(non inclus):
2 Ampoules Lunettes de Protection Echelle Gants Dénudeur de
(60 watts maxima) Câbles Electriques
(ou équivalent LFC)
Tournevis à Tête Plate Tournevis à Croisillon Ruban Adhésif Isolant Pince pour Câbles Electriques
Page 6
PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
3ea Wire Connectors (#12) 2ea Outlet Box Screws (#13) 1ea Mounting Strap (#14)
1ea Ground Screw (#15) 2ea Mounting Screws (#16)
INSTALLATION INSTRUCTIONS:
1. Screw the two Mounting Screws (#16) into the
Mounting Strap (#14). Mount the
Mounting Strap (#14) to the Outlet Box (#11) using the two Outlet Box Screws (#13).
[Make sure the heads of the Mounting Screws (#16) are facing outside when the
Mounting Strap (#14) is attached to the Outlet Box (#11).]
2. Wrap the ground wire from the fixture around the Ground Screw (#15) on the
Mounting
Strap
(#14), and then connect the ground wire from the fixture to the ground wire from
the Outlet Box (#11). Connect the white wire from the fixture to the white wire (neutral
wire) from the Outlet Box (#11). Connect the black wire from the fixture to the black
wire (live wire) from the Outlet Box (#11). Cover the three connections using the three
Wire Connectors (#12). Wrap the three wire connections with electrical tape for a more
secure connection. Position the wires back inside the Outlet Box (#11). Note: If you have
electrical questions, consult your local electrical code for approved grounding methods.
3. Place the Canopy (#1) over the Outlet Box (#11). Allow the heads of the Mounting
Screws (#16) to come out through the large ends of the keyholes on the Canopy (#1).
Twist the Canopy (#1)
clockwise until the heads of the Mounting Screws (#16) slide into
the narrow ends of the keyholes. Tighten the Mounting Screws (#16) to secure the
Canopy (#1).
4. Before completing Installation, please return to Assembly Instruction #4.
5. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the
light switch on to activate the fixture.