Instructions / Assembly

Page 19
AVERTISSEMENT:
1. Avant de commencer à installer ce luminaire ou d'enlever l'ancien luminaire,
déconnectez le courant en éteignant le disjoncteur ou en enlevant le fusible
correspondant du coffret à fusibles.
2.
CONSULTER UN ELECTRICIEN QUALIFIE POUR TOUTE
QUESTION RELATIVE A L'ELECTRICITE.
3.
En cas de questions non relatives à l'électricité à propos de ce luminaire,
veuillez contacter notre centre de Service à la Clientèle au 1-877-527-0313
ou visiter www.homedepot.com. Veuillez indiquer votre UGS 228-470 o
UPC 6940500310480.
4.
Conserver votre reçu et ces Instructions comme Preuve d'Achat.
OUTILS REQUIS POUR L'ASSEMBLAGE & L'INSTALLATION
(non inclus):
Ampoule Lunettes de Protection Echelle Gants Dénudeur de Câbles Electriques
(60 watts maxima)
(ou équivalent LFC)
Tournevis à Tête Plate Tournevis à Croisillon Ruban Adhésif Isolant Pince pour Câbles Electriques
Page 6
PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
1ea Lock Nut (#2) 3ea Wire Connectors (#11) 2ea Outlet Box Screws (#12)
1ea Hex Nut (#13) 1ea Mounting Strap (#14) 1ea Nipple (#15) 1ea Ground Screw (#16)
INSTALLATION INSTRUCTIONS:
1. Screw the Nipple (#15) a half-inch into the Mounting Strap (#14). Tighten the Hex Nut
(#13) against the Mounting Strap (#14) to secure the Nipple (#15). Attach the Mounting
Strap (#14) to the Outlet Box (#10) using the two Outlet Box Screws (#12). [Make sure the
longer end of the Nipple (#15) is facing outside when the Mounting Strap (#14) is attached
to the Outlet Box (#10).]
2. Wrap the ground wire from the fixture around the Ground Screw (#16) on the Mounting
Strap (#14), and then connect the ground wire from the fixture to the ground wire from the
Outlet Box (#10). Connect the white wire from the fixture to the white wire (neutral wire)
from the Outlet Box (#10). Connect the black wire from the fixture to the black wire (live
wire) from the Outlet Box (#10). Cover the three wire connections using the three Wire
Connectors (#11). Wrap the three wire connections with electrical tape for a more secure
connection. Position the wires back inside the Outlet Box (#10). Note: If you have
electrical questions, consult your local electrical code for approved grounding methods.
3. Place the fixture body on the wall by aligning the protruding Nipple (#15) all the way
through the hole on the Wall Plate (#1). Tighten the fixture to the wall by screwing the
Lock Nut (#2) onto the protruding Nipple (#15).
4. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the light
switch on to activate the fixture.