Installation Guide
CABINET(S) INSTALLATION
1. Lay the cabinet down so that the doors are facing upwards (Fig.#1).
2. Align the feet of the cabinet with the corresponding pre-drilled holes on the base of the cabinet (Fig.#1).
3. Secure each leg to pre-drilled holes with 1.5” screws (included with cabinet) (Fig.#1).
CABINET LEGS INSTALLATION
Customer Service
1(800) 235-7747
INSTALLATION INSTRUCTIONS
FOR KITCHEN CABINETS
TO INSTALL CABINETS ON SHEETROCK WALLS
1. Place the cabinet in desired location with doors facing outward (Fig.#2).
2. Locate studs in back wall and mark upper back panel of the cabinet to corresponding stud.
Secure cabinet to wall with appropriate screws, be sure to drill in to at least 3 studs.
(Cabinet MUST be secured to wall studs for support) (Fig.#2).
For the 40cm base locate 1 stud in back wall and secure cabinet to stud with one screw in upper
cleat and one screw in lower cleat.
TO INSTALL CABINETS ON CONCRETE WALLS
1. Place the cabinet in desired location with doors facing outward (Fig.#2).
2. Drill 4 holes in the upper cleat leaving 10cm on each end, centering the other 2 holes. Drill throught
the cabinet as to leave a mark on the back wall that will indicate where to insert the wall anchors
(40cm cabinets only require 2 holes, leaving 10cm from each end) (Fig.#2).
3. Remove the cabinet and install anchors into wall where marks indicate.
4. Once anchors are installed, place cabinet back in original position and insert the screws through the
original holes made, being sure that screws are inserted into wall anchors.
SINK INSTALLATION
1. Turn sink upside down.
2. Insert the brackets (included) into the sink slots so that the metal part of bracket points to the
exterior part of sink (Fig.#1).
3. Place gasket around the edge of sink which will sit on countertop.
4. Insert sink in cut-out of counter top, be sure that sink is oriented correctly with faucet holes in back.
5. From beneath countertop, secure sink base to countertop using adjustable brackets attached to sink
base (Fig.#2).
CABINET CARE & MAINTENANCE
To clean surface of doors or cabinet, use non-abrasive cleaners and or cleaning agents that do not contain solvents.
COUNTER TOP INSTALLATION
1. Remove the drawers by opening to full extension and lifting slightly to release
drawer from sliding track.
2. Install metal corner brackets (included) to all 4 sides of cabinet, flush with top of
side walls (Fig. 1).
3. Place counter top on top of cabinet and secure to brackets using appropriate
screws (included in bag with brackets) (Fig. 2).
Fig.#2
Fig.#1
Fig.#1
Corners
Fig.#2
Fig.#2
Fig.#1