Instructions / Assembly
Care and Cleaning
Troubleshooting
□
□
Do not use any cleaners with chemicals, solvents, or harsh abrasives. Use only a dry, soft cloth to dust or wipe carefully.
To clean the xture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box, and use a dry or
slightly dampened, clean cloth to wipe the exterior surface of the xture.
7
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
□
□
□
□
□
□
□
Problem Possible Cause Solution
The light(s) will not turn on. The bulb is burned out. Replace the light bulb.
The power is off. Ensure the power supply is turned on.
There is a faulty switch. Test or replace the switch.
Check the wiring.
There is a faulty wire connection.
The fuse blows or the circuit breaker
trips when the light is turned on.
There are crossed wires, or the power
wire is grounding out.
Discontinue use of the light.
Check the wire connections.
Contact a qualied electrician or call the Customer Care
Service Team at 1-855-HD-HAMPTON.
Installation (continued)
7
Using silicone sealer
□
□
□
Make sure the surface of the exterior wall and the xture backplate are free of dirt.
Using silicone sealer (not included) start on one side of the xture backplate and follow the contour where the xture
backplate meets the exterior wall surface.
Proceed to seal around backplate.
NOTE: To ensure proper moisture drainage, do not seal
bottom of xture backplate.