Instructions / Assembly

Installation

□

Installing the crossbar assembly

Secure the crossbar assembly (AA) to the outlet box (not

included) with the outlet box screws (BB). Tighten until snug.

NOTE: The preassembled mounting screws on

the crossbar should protrude outward.

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

NOTE: Prior to installation, close or cover the sink

drain and/or any vents near the installation site to

prevent loss of mounting hardware if dropped.

NOTE: The backplate on the xture body (A) should be snug against the wall and

the mounting balls (1).

Test tting backplate on the xture body to the crossbar assembly

□

Fit the backplate on the xture body (A) to the crossbar assembly (AA) and secure with the mounting balls (1).

If this does not work, adjust the length of the mounting screws on the crossbar assembly (AA) by unscrewing the preassembled hex

nuts.

Screw the mounting screws in or out of the crossbar assembly (AA) until the desired length is achieved.

Once the backplate on the xture body (A) is secure, remove the mounting balls (1) and xture body (A) and proceed to Step 4.

Preparing the crossbar assembly

□

Unscrew the two mounting balls (1) from the xture body (A).

Remove the crossbar assembly (AA) from the xture body (A) and

keep the crossbar assembly (AA) and two mounting balls (1) for

later use.

Unscrew the two mounting screws (3) from the xture body (A).

Remove the cage (2) and the EPE (4) from the xture body (A) and

keep the cage (2) and the two mounting screws (3) for later use.