Instructions / Assembly

20
Installation
19
BOOKCASE
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
o Installation of a bookcase by itself is NOT recommended unless
additional support such as attachment to a soffit or supported by a
countertop. Bookcases that are 54" or 60" high are designed to
mount on a countertop and must be secured to the wall.
o Follow the Minimum Attachment Requirements found earlier.
20
VANITY SINK CABINETS
o Transfer the location of the supply and drain lines to the back or
bottom of the cabinet. Using a hole saw, cut openings 1/4” larger
than that of the pipe at these locations.
o Follow the Minimum Attachment Requirements found earlier.
METAL VENT
CLIP
#5 X 5/8 FLAT
HEAD SCREW
BACK SIDE OF
DRAWER VENT
2 3/4˝
TRADITIONAL OVERLAY 15/16˝
FULL OVERLAY 1-5/8˝
WARNING: Bookcase cabinets are subject to extreme
weight. Bookcase cabinets
used for wall hung applications must be limited to 15 lbs.
per sq. ft. of shelf area and should not be hung on the wall.
FAILURE TO FOLLOW THESE LIMITATIONS COULD CAUSE
SERIOUS INJURY AND WILL VOID THE PRODUCT WARRANTY.
Special depth bookcase cabinets greater than 12” deep
should not be used in wall hung applications.
o The drawers can be changed to a false front if twin or off-center sink
bowl locations are required.
o Remove the drawer. Unscrew the Drawer Front from the Drawer Box.
Unscrew the Drawer Guide from the Face Frame and pull the guide
out of the cabinet back.
o Drill a 1/8" diameter 1/2" deep hole on each side of the drawer
opening in the face frame as shown; 2-11/16" from the bottom of
the drawer opening and 5/16" in from the front of the face frame.
Install the (2) plastic strikes in the holes drilled in the face frame
using the provided #8 X 1" pan head screws.
o Lay the Drawer Front face down on a protected surface. Drill a 3/32"
diameter 1/2" deep hole as shown. For full overlay door styles, the
hole is located 2-3/4" from the bottom of the drawer front and
1-5/8" from the side of the drawer front. Repeat on both sides.
o Install the (2) metal clips in the pre-drilled holes on the back side of
the drawer front using the provided screws. Snap the Drawer Front
onto the drawer opening.
21
CONVERSION OF VANITY DRAWERS TO FALSE
FRONT
2
11/16"
5/16"
PAN HEAD SCREW
PLASTIC VENT STRIKE
1/8" DIAMETER x
1/2" DEEP