Instructions / Assembly

16
Installation
13
BASE CORNER CABINETS
o Wall Fillers are available to fill gaps between the end of a row of
cabinets and a 90° wall.
INSTALLER NOTE: A Backer Board is required behind the Wall
Filler if the Filler is wider than 3". Attach the Backer Board to the wall
before installing the final cabinet.
14
WALL FILLER; BASE, WALL
o The approach to install Base Corner cabinets is to attach the
adjacent cabinets on each side and install the group of cabinets as a
unit.
o Dry fit the Base Corner cabinet into the corner with both adjacent
cabinets in place on each side. Align the face frames on the top
and front surfaces, and clamp the cabinets together; do not drill.
When installed, the back of the Base Corner cabinet will not touch
the wall.
o Measure for Countertop Braces and install per the requirements
found earlier. Brace length varies based on cabinet model.
o With the cabinets in final position, shim so they match the Base
Cabinet Top Level Line, and all frames are flush and plumb.
o Predrill through the adjacent cabinet face frames into the Base
Corner cabinet and fasten with 2-1/2" screws, per the Frame-to-
Frame Attachment requirements.
INSTALLER NOTE: For Base Lazy Susan cabinets, use 2" screws
per Screw Requirements.
o To mark the Wall Filler and Backer Board positions, run a straight
edge across the space between the wall and the closest cabinet. On
the wall, mark behind the straight edge. Draw a straight, vertical line
from this mark using a level. Align the front of the Filler on this mark.
Mark behind the Filler for the front position of the Backer Board.
o Attach the Backer Board to the wall so it is plumb. Be sure that the
Backer Board is wide enough to be fastened to the nearest wall stud.