Instructions / Assembly

HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
PACKAGE CONTENTS
Assembly and Installation
Attaching and installing the light
1
Item #1007 976 444
Model #99206
□ Detach and place the wire connector (E) on opposite sides of the low
voltage cable (not included) where the xture will be located.
□ Align and t the main low voltage cable vertically in the slot of the wire
connector as shown.
□ Press the wire connector (E) together until it is fully seated and locked
around the cable. Pre-set prongs will pierce the cable insulation and
establish contact.
□ If the light xture does not turn on, repeat the previous 3 steps.
□ Once the clip-on connector is in place, we recommend wrapping it in
electrical tape (not included) for additional protection.
□ Attach the xture head (A) to the top post (B) by inserting the upper end of
the top post (B) into the xture head and then twisting clockwise.
□ Attach the top post (B) to the bottom post (C) by inserting the top of the
bottom post (C) into the bottom of the top post (B) and twisting clockwise.
□ Insert the xture wire (2) into the groove located on the top of the ground
stake.
□ Attach the bottom post (C) to the stake (D) by placing the bottom of the
post (C) onto the top of the stake (D) and twisting clockwise.
□ Prepare a hole in the installation location. Use a screwdriver to prepare
the installation hole to ensure that the hole is not larger than the stake (D).
□ Install the xture in the ground by pushing on the foot step (1) on the
stake (D). Do not push the xture head.
Connecting the wires
2
A - Fixture head x 1 B - Top post x 1 D - Stake with foot step x 1
E - Connector with
12 in. wire length
(attached to xture) x 1
CAUTION: The wire from the low voltage power unit shall
be 12-16 AWG type underground Low Energy Circuit
Cable.
IMPORTANT: Protect the wiring by routing it in close
proximity to the light, or next to a building structure such as
a house or deck.
Do not bury the wiring by more than 6 in. (15.24 cm) in
order to connect to the main secondary wire.
Do not submerge xtures in water.
NOTE: Do not use a hammer. If the ground is hard, use
water to soften it or a trowel to loosen the soil.
WARNING: The connector contacts (D) have sharp edges
for piercing the main low voltage cable. To avoid injury,
do not touch the metal contacts.
C - Bottom post x 1
WARNING: Risk of electric shock do not install the light
within 10 ft. (3.05 m) of a pool, spa or fountain.
A B C D
E
A
B
C
2
1
E
D
E
Use and Care Guide
Covington
LED Low Voltage Path Light