Installation Guide

12
Assembly (continued)
Locate the “L” Corner Brace (O), Top Corner Extension (P)
and set out face down on a scratch-free surface.
Insert Bolts (AA) through the holes in the Plastic
Connector and tighten.
Attach the Completed assembly from step 14 into
place at the back of Mantel.
Insert wood dowel (CC) into the holes in the back of Top
Mantel (G).
Use a Phillips head screwdriver to tighten Bolts (AA)
through plastic connector.
14
15
“L” Corner Brace installation
Top Corner Extension installation
Hardware Used
Hardware Used
Part Description Qty
AA Bolt 1
Part Description Qty
AA Bolt 4
CC Wood Dowel 4
AA
CC
O
P
AA
AA
CAUTION:
Cold climate installation recommendation: When installing this unit against a non-insulated exterior wall or chase, it is
mandatory that the outer walls be insulated to conform to applicable insulation codes.
CAUTION:
A 15-Amp, 120-V, 60 Hz circuit with a properly grounded outlet is required. Preferably, the replace will be on a dedicated
circuit as other appliances on the same circuit may cause the circuit breaker to trip or the fuse to blow when the heater is in operation. The
unit comes standard with 6-ft. three-wire cord, exiting from the rear of the replace. Avoid using an extension cord. If an extension cord must
be used, it must be a minimum 14 AWG, three wire with grounding type plug connector and rated not less than 1875 watts. Do not use an
extension cord more than 20 ft. in length.