Installation Guide

4
Installation
IMPORTANT: Prior to use, set the AUTO/OFF switch located
on the back of the solar box to the AUTO position and allow it to
charge a full sunny day.
NOTE: Do not use a hammer. If the ground is hard, use water to
soften.
□ Insert the ground stake (C) firmly into the ground at the installation location. If the ground is too hard, soak the ground with water to soften
the ground or drive a metal rod or screwdriver into the ground to create a hole for the ground stake assembly.
□ Connect the upper stake (B) to the ground stake (C).
□ Connect the solar assembly (A) to the upper stake (B).