Instructions / Assembly

12
Assembly - Hanging the Fan (continued)
Attaching the fan blades
9
□ Attach a blade (F) to the fan motor housing (E) by rst
inserting the blade (F) into the slot in the side of the fan
motor housing (E).
□ Insert a screw (AA) into the bracket. Repeat for the two
remaining screws.
□ Tighten each screw (AA) securely.
□ Repeat these steps for the remaining blades (F).
Attaching the light kit tter assembly
1
□ Remove one screw (RR) from the black bracket below fan
motor assembly (E). Loosen but do not remove three of four
mounting screws.
□ Connect the blue wire exiting the bottom of the fan motor
assembly (E) with the black wire from the light kit tter
assembly (G).
□ Connect the white wire exiting the bottom of the fan motor
assembly (E) with the white wire from the light kit tter
assembly (G).
□ Push the light kit tter assembly (G) up to the fan motor
assembly (E) so that the three loosened screw heads t into the
keyhole slots. Turn the light kit tter assembly (G) to secure.
□ Re-install the screw that was removed in step 1.
CAUTION: To reduce the risk of electric shock,
disconnect the electrical supply circuit to the fan before
installing the light kit.
WARNING: Do not overtighten when installing the glass
shade into the light kit assembly. Allow the glass shade to
cool completely before removing.
Installing the glass bowl
2
□ With the power off, install the two LED bulbs (K)(9.5 Watt,
max) by screwing them into the light bulb sockets.
□ Place the glass bowl (H) into the light kit pan (G), aligning
the three at areas on the top ange of the glass bowl (H)
with the three raised dimples in the light kit pan (G).
□ Turn the glass bowl(H) clockwise until it stops.
AA
F
E
Assembly - Installing the Light Kit
G
RR
H
K
G