Instructions / Assembly

ManualsBrandsHampton Bay ManualsLightingSolar No Voltage 20 Lumens Black Outdoor Integrated LED Clip-On Light with Magnet; Weather/Water/Rust Resistant

Table Of Contents

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

PACKAGE CONTENTS

Assembly and Installation

Preparing for installation

□ Attach the light to a thin rail using the clip (D). Squeeze the tabs on the

top of the clip to open. Release the tabs to close the clip (D).

Item #1005 698 079

Model #62001

□ Attach the light to a steel surface using the magnet located on the

back of the clip (D).

□ FOR FIRST TIME USE: Slide the clip (D) into the slot on the light body (A)

(pre-installed).

□ Remove the pull-tab from the light body.

Option 1 - Magnetic mount

Option 2 - Clip mount

Magnet

NOTE: The magnetic clip can only attach to a steel surface.

Use and Care Guide

Solar LED Clip Light

PLANNING FOR A SUCCESSFUL ASSEMBLY

Read all instructions before assembly and installation.

Inspect each part for defects that may have occurred during shipping.

Keep your receipt and these instructions for proof of purchase.

CHOOSING THE RIGHT LOCATION

Install your solar light in a location with full, direct sunlight. Do not install in shaded areas as these areas will not allow the batteries to fully charge and will reduce

the nighttime operating hours for your light. Ensure that the installation location is away from other nighttime light sources such as street or porch lamps. These light

sources may prevent your solar light from automatically turning on.

HOW SOLAR WORKS

The solar light has a solar panel that converts sunlight into electricity. During the day, the converted electricity is stored in the rechargeable batteries. At night, the

solar light is powered by the batteries using the electricity stored during the day. The operating time depends on geographical location, daily weather conditions, and

season. For optimal performance during the evening, allow the batteries to charge for 6 to 7 hours in direct sunlight.

A - Light body x 1 B -14430 3.2V 450 mAh LiFeP04

rechargeable battery (pre-installed) x 1

C - Battery cover

(pre-installed) x 1

D - Clip with magnet

(pre-installed) x 1

Summary of content (4 pages)

PAGE 1
Item #1005 698 079 Model #62001 Use and Care Guide Solar LED Clip Light PACKAGE CONTENTS A A - Light body x 1 D C B B -14430 3.2V 450 mAh LiFeP04 rechargeable battery (pre-installed) x 1 C - Battery cover (pre-installed) x 1 D - Clip with magnet (pre-installed) x 1 PLANNING FOR A SUCCESSFUL ASSEMBLY Read all instructions before assembly and installation. Inspect each part for defects that may have occurred during shipping. Keep your receipt and these instructions for proof of purchase.
PAGE 2
Maintenance Replacing the battery C CAUTION: When replacing the battery, use one (1) 14430 3.2V 450 mAh LiFeP04 rechargeable battery. IMPORTANT: Dispose of the batteries in accordance with local, state, and federal regulations. A NOTE: For best performance, replace with a rechargable 3.2V 14430 450mAh LiFeP04 battery or greater every 3 years or when performance diminishes. C B □ Remove the screw and open the battery cover (C). □ Replace the old battery with one (1) new 14430 3.
PAGE 3
Artículo #1005 698 079 Modelo Núm.62001 Guía de uso y cuidado Lámpara LED solar con presilla CONTENIDO DEL PAQUETE A A - Cuerpo de la lámpara x 1 D C B B -Batería AA (preinstalada) recargable 14430 LiFeP04 de 3.2 V y 450 mAH x 1 C - Cubierta de la batería (preinstalada) x 1 D - Clip con imán x 1 PLANIFICACIÓN DEL ENSAMBLAJE EXITOSO Lee todas las instrucciones antes de ensamblar e instalar. Verifica que ninguna de las piezas haya sufrido daños durante el envío.
PAGE 4
Mantenimiento Cómo reemplazar la batería C PRECAUCIÓN: Al reemplazar la batería, usa una (1) batería recargable 14430 LiFeP04 de 3.2 V y 450 mAh. IMPORTANTE: Desechar las baterías de acuerdo con las regulaciones locales, estatales y federales. A NOTA: Para un mejor funcionamiento, reemplazar con baterías recargables 14430 LiFeP04 de 3.2 V y 450 mAh o más cada 3 años o cuando disminuya el rendimiento. C B □ Retirar el tornillo y abrir la cubierta de la batería (C).