Installation Guide

ManualsBrandsHampton Bay ManualsLightingSolar No Voltage 20 Lumens Black Outdoor Integrated LED Clip-On Light with Magnet; Weather/Water/Rust Resistant

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

PACKAGE CONTENTS

PLANNING FOR A SUCCESSFUL ASSEMBLY

Read all instructions before assembly and installation.

Inspect each part for defects that may have occurred during shipping.

Keep your receipt and these instructions for proof of purchase.

CHOOSING THE RIGHT LOCATION

Install your solar light in a location with full, direct sunlight. Do not install in

shaded areas as these areas will not allow the batteries to fully charge and will

reduce the nighttime operating hours for your light. Ensure that the installation

location is away from other nighttime light sources such as street or porch lamps.

These light sources may prevent your solar light from automatically turning on.

Part Description Quantity

A Light body 1

14430 3.2V 450 mAh LiFeP04 rechargeable

battery (pre-installed)

C Battery Cover (pre-installed) 1

D Clip with magnet 1

HOW SOLAR WORKS

The solar light has a solar panel that converts sunlight into electricity. During the day, the converted electricity is stored in the rechargeable batteries. At night, the

solar light is powered by the batteries using the electricity stored during the day. The operating time depends on geographical location, daily weather conditions, and

season. For optimal performance during the evening, allow the batteries to charge for 6 to 7 hours in direct sunlight.

Assembly and Installation

Preparing for installation

□ Attach the clip (D).

Solar LED Path Light

Use and Care Guide

Item #xxxx xxx xxx

Model #62001

□ Attach the clip (D).

□ FOR FIRST TIME USE: Slide the clip (D) off of the slot on the light body (A)

(pre-installed).

□ Remove the pull-tab from the light body.

□ Re-insert the clip (D) onto the light body (A).

Installing the solar light on the steel board

(Option 1)

Installing the solar light on the steel board

(Option 2)

Magnetic

NOTE: The magnetic clip can only attach to the steel board or post.

Summary of content (2 pages)

PAGE 1
Use and Care Guide Solar LED Path Light Item #xxxx xxx xxx Model #62001 PACKAGE CONTENTS A C B PLANNING FOR A SUCCESSFUL ASSEMBLY D Part Description Quantity Read all instructions before assembly and installation. A Light body 1 Inspect each part for defects that may have occurred during shipping. B 1 Keep your receipt and these instructions for proof of purchase. 14430 3.
PAGE 2
Maintenance Replacing the battery C CAUTION: When replacing the battery, use one (1) 14430 3.2V 450 mAh LiFeP04 rechargeable battery. IMPORTANT: Dispose of the batteries in accordance with local, state, and federal regulations. A NOTE: For best performance, replace with a rechargable 3.2V 14430 450mAh LiFeP04 battery or greater every 3 years or when performance diminishes. C B □ Remove the screw and open the battery cover (C). □ Replace the old battery with one (1) new 14430 3.