Instructions / Assembly

13
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Attaching the light kit tter assembly
2
□ Remove one screw (RR) from the black bracket below fan
motor assembly (E). Loosen but do not remove three of
four mounting screws.
□ Connect the blue wire exiting the bottom of the fan motor
assembly (E) with the black wire from the light kit tter
assembly (F).
□ Connect the white wire exiting the bottom of the fan motor
assembly (E) with the white wire from the light kit tter
assembly (F).
□ Push the light kit tter assembly (F) up to the fan motor
assembly (E) so that the three loosened screw heads t into
the keyhole slots. Turn the light kit tter assembly (F) to
secure.
□ Re-install the screw that was removed in step 1.
CAUTION: To reduce the risk of electric shock,
disconnect the electrical supply circuit to the fan before
installing the light kit.
WARNING: Do not overtighten when installing the glass
shade into the light kit assembly. Allow the glass shade to
cool completely before removing.
Installing the glass bowl and light
bulbs
3
□ With the power off, install the two LED bulbs (M) (9.5 Watt,
max) by screwing them into the light bulb sockets.
□ Remove the nial (WW), hex nut (SS) and rubber washer
(XX) from the threaded nipples of the light kit tter
assembly (F).
□ Position the glass bowl (I) into the light kit pan (H) over the
threaded nipple.
□ Re-install the rubber washer (XX) and the hex nut (SS) to
the threaded nipple, hand tighten the hut (SS) to secure.
□ Re-install the nial (WW) to the threaded to secure the
glass bowl (I) properly.
Assembly - Installing the Light Kit (continued)
RR
F
H
F
I
M
XX
SS
WW