Manualshelf

Instructions / Assembly

ManualsBrandsHampton Bay ManualsFlushmount Lights4 ft x 10 in. Mission Style 200 Watt Equivalent Brushed Nickel Integrated LED Flushmount
12345678910
4
1
Separating the diffuser shade from
the fixture plate
□ Open the latches on the fixture plate (A).
□ Remove the diffuser shade (B).
2
Preparing to mount the fixture
□ With help from another person, temporarily hold the fixture
plate (A) up to the ceiling to determine the best mounting
position and which knock out hole to use for wiring the
fixture.
□ Mark the four keyhole mounting positions of the fixture
plate (A) on the ceiling.
□ Drill a 1/8 in. pilot hole into each of the screw locations
marked on the ceiling. You can also use an awl or nail to
dimple the screw holes.
□ Install a drywall anchor (BB) and a mounting screw (CC) in
each drilled mounting hole, but do not tighten fully.
NOTE: The drywall anchors (BB) are only to be used for
mounting the fixture onto plaster or drywall surfaces.
Installation
WARNING: RISK OF ELECTRIC SHOCK. Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off the
circuit breaker before removing the existing light fixture or installing the new one.
With power disconnected to the electrical box, remove the existing fixture. Make a sketch of how the current fixture is wired (by wire color)
or mark the wires with masking tape and a pencil so you will know how to properly reconnect the wires to the new LED light fixture.
A
B
A
B
BB
A
Keyholes
Knock outs
CC
Keyholes