Instructions / Assembly

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Operation

Remote Control - Your fan is equipped with a remote control to

operate the speed and lights of your new ceiling fan.

The appropriate speed settings for warm or cool weather depend

on factors such as the room size, ceiling height, and number of

fans.

The fan is shipped from the factory with the reversing switch

positioned to circulate air downward. If airow is desired in the

opposite direction, turn your fan off and wait for the blades to stop

turning. Slide the reversing switch (located at the top of the motor

housing) to the opposite position, and turn the fan on again. The fan

blades will turn in the opposite direction and reverse the airow.

1. Speed - The remote features Low, Med, Hi and Off buttons to select

the desired speed of operation and turn the fan On or Off.

2. Light - To control the light kit, the remote features a Light/Dimmer

button.

Operating the fan

High button = High speed

Medium button = Medium speed

Low button = Low speed

Off button = Power off

Light/Dimmer = Dims light with memory

Cool weather - (Reverse) An upward airow moves warm air off of

the ceiling. This allows you to set your heating unit on a cooler set-

ting without affecting your comfort.

Warm weather - (Forward) A downward airow creates a cooling ef-

fect. This allows you to set your air conditioner on a warmer setting

without affecting your comfort.

NOTE: The reverse switch is located at the top of motor housing.

Shut the fan off and wait until the blades have completely stopped

before ipping the switch to reverse the direction of your ceiling

fan.

Installing the light bulbs and glass

bowl

□ With the power off, install the light bulbs (M) (Max. 8.5W,

provided) into the light bulb sockets.

□ Place the glass bowl (J) into the light kit tter assembly (F),

aligning the three at areas on the top ange of the glass

bowl (J) with the three raised dimples in the light kit tter

assembly (F). Turn the glass bowl (J) clockwise until it stops.

WARNING: Do not overtighten when installing the glass shade

into the light kit assembly. Allow the glass shade to cool

completely before removing.

Assembly - Attaching the Light Kit (continued)