Installation Guide

Assembly - Attaching the Light Kit

Attaching the light kit Installing the light bulbs

12 13

□ Remove one screw (N) from the black bracket below the

fan-motor assembly (E). Loosen, but do not remove the

other two screws.

□ Connect the blue wire exiting the bottom of the fan-motor

assembly (E) with the black wire from the top of the light

kit tter assembly (F).

□ Connect the white wire exiting the bottom of the fan-motor

assembly (E) with the white wire from the top of the light

kit tter assembly (F).

□ Attach the light kit tter (F) to the fan-motor assembly (E)

by securing them with the two screws (N) loosened in the

rst step. Push the light kit tter assembly (F) up to engage

the screw heads in the screw slots and turn to secure.

Tighten each screw rmly.

□ With the power off, install the light bulbs (L) (Max. 14W,

provided) into the light bulb sockets.

□ Place the glass bowl (J) into the light kit tter assembly (F),

aligning the three at areas on the top ange of the glass

bowl (J) with the three raised dimples in the light kit tter

assembly (F). Turn the glass bowl (J) clockwise until it stops.

CAUTION: To reduce the risk of electric shock, disconnect

the electrical supply circuit to the fan before installing the

light kit.

WARNING: Do not overtighten when installing the glass shade

into the light kit assembly. Allow the glass shade to cool

completely before removing.