Installation Guide

7
HAMPTONBAY.COM
Please contact 1-877-527-0313 for further assistance.
Assembly - Standard Ceiling Mount
Routing the wires
Assembling the fan
Preparation for mounting
□ Loosen, but do not remove, the setscrew on the collar (K) on
top of the fan-motor assembly (D).
□ Align the holes at the bottom of the ball/downrod assembly
(B) with the holes in the collar (K) on top of the fan-motor
assembly (D).
□ Carefully insert the hanger pin (CC) through the holes in the
collar (K) and ball/downrod assembly (B). Be careful not to
jam the hanger pin (CC) against the wiring inside the ball/
downrod assembly (B).
□ Insert the locking pin (DD) through the hole near the end of
the hanger pin (CC) until it snaps into its locked position.
□ Re-tighten the setscrews on the collar (K) on top of the
fan-motor assembly (D).
□ Remove the canopy ring from the canopy (C) by turning the
ring to the right until it unlocks.
□ Remove the slide-on mounting bracket (A) from the canopy
by loosening the four screws on the top of the canopy (C).
□ Remove the two non-slotted screws and loosen the
slotted screws. This will enable you to remove the slide-on
mounting bracket (A).
□ Route the wires exiting the top of the fan-motor
assembly (D) into the decorative motor collar cover (F)
and through the canopy ring (C).
□ Make sure the slot openings are on top and route the
wires through the canopy (C) and then through the ball/
downrod assembly (B).
2
3
1
A
C
D
F
C
B
D
CC
DD
K
B
WARNING: Failure to properly install the locking pin could
result in the fan becoming loose and possibly falling.