Installation Guide

Operating Your Fan

Assembly - Assembling the Fan Without the Light Kit

Assembling the fan without the

light kit

□ In order to use the fan without the light kit, remove the switch

cup (L) from the top of the light kit tter assembly by removing

the center hex nut inside the switch cup (L).

□ Thread the switch cup (L) off of the threaded nipple on the top

of the light kit tter assembly.

□ Remove the four screws (OO).

□ Press the plastic plug (EE) into the center hole of the switch

cup (L).

□ Align the four screw holes in the switch cup (L) with the four

screw holes in the switch cup cover.

□ Position the switch cup (L) onto the black bracket and install

the screws (00) that were removed in the rst step.

The pull chain controls the fan speed as follows:

1 pull - High, 2 pulls - Medium, 3 pulls - Low, and 4 pulls - Off

Speed settings for warm or cool weather depend on factors such as

room size, ceiling height, number of fans, and so on.

The slide switch controls the direction: forward (switch left) or reverse

(switch right).

Warm weather - (Forward) A downward airow creates a cooling effect.

This allows you to set your air conditioner on a higher setting without

affecting your comfort.

Cool weather - (Reverse) An upward airow moves warm air off of the

ceiling. This allows you to set your heating unit on a lower setting

without affecting your comfort.

NOTE: Wait for the fan to stop before reversing the direction of the blade

rotation.