Installation Guide

7
HAMPTONBAY.COM
Please contact 1-877-527-0313 for further assistance.
Routing the wires
Assembling the fan
Preparing for standard mounting
□ Loosen, but do not remove, the setscrews (HH) on the collar
on top of the fan-motor assembly (D).
□ Align the holes at the bottom of the ball/downrod assembly
(B) with the holes in the collar on top of the fan-motor
assembly (D).
□ Carefully inset the hanger pin (DD) through the holes in
the collar and ball/downrod assembly (B). Be careful not to
jam the hanger pin (DD) against the wiring inside the ball/
downrod assembly (B).
□ Insert the locking pin (EE) through the hole near the end of
the hanger pin (DD) until it snaps into its locked position.
□ Re-tighten the setscrews (HH) on the collar on top of the
fan-motor assembly (D).
□ Remove the canopy ring (L) from the canopy (C) by turning
the canopy ring (L) to the right until it unlocks.
□ Remove the slide-on mounting bracket (A) from the canopy
(C) by loosening the four screws (SS) on the top of the
canopy (C).
□ Remove the two non-slotted screws (SS) and loosen the
slotted screws (SS). This will enable you to remove the
slide-on mounting bracket (A).
□ Make sure the slot openings are on top and route the
wires exiting the top of the fan-motor assembly (D)
through the canopy (C) and the canopy ring (L) and then
through the ball/downrod assembly (B).
2
3
1
A
C
SS
L
C
B
D
L
B
D
DD
EE
HH
WARNING: Failure to properly install the locking pin (EE)
could result in the fan becoming loose and possibly
falling.
Assembly - Standard Ceiling Mount