Installation Guide

HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Installing the glass bowl for fans

with pull chains

Installing the glass bowl for fans

without pull chains

Installing the bulbs

□ Before installing the light kit (A) to the fan, remove the pull chain guide (GG) with screw

driver from the top cover.

□ Follow steps 1-4 to install the light kit to the fan and bulbs to the light kit.

□ Remove the pre-installed nial (LL), outer bowl cap (KK), hex nut (JJ) and rubber washer

(HH) from the light kit (A) and save them for later use.

□ Align the glass bowl (C) over the threaded nipple (HH) and raise the glass bowl up to the

light kit (A).

□ Pass the chain through the rubber washer (II), hex nut (JJ) and tighten them with a screw

driver.

□ Pass the chain through the outer bowl cap (KK) and align it on the threaded nipple (HH)

and lock it with the nial (LL). Finger tighten.

□ Attach the pull chain extensions (CC) to the light switch chain.

□ Install two 14 watt Medium base CFL bulbs (B) (provided)

into the light kit bulb sockets (F).

□ Pass the fan switch chain through the hole of the pull

chain guide (GG).

□ Remove the pre-installed nial (LL), outer bowl cap (KK),

hex nut (JJ) and rubber washer (II) from the light kit (A)

and save them for later use.

□ Align the glass bowl (C) over the threaded nipple (HH)

and raise the glass bowl up to the light kit (A).

□ Pass the chain through rubber washer (II), hex nut (JJ)

and tighten them with the screw driver.

□ Pass the chain through the outer bowl cap (KK) and align

it on the threaded nipple (HH) and lock it with the nial

(LL) by nger tight.

□ Attach the pull chain extensions (CC) to the light switch

chain and the fan switch chain.

CAUTION: Do not over-tighten the hex nut. Over-

tightening the hex nut may cause the glass bowl (C)

to crack or break.

Installation (continued)

CAUTION: Do not over-tighten the hex nut. Over-

tightening the hex nut may cause the glass bowl (C)

to crack or break.