Installation Guide

Page 6
PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
1 Ground Screw (#18) 2 outlet Box Screw (#13) 2 Nut (#12) 3 Wire Connectors (#16)
1 Circular Strap (#14) 2 Screw Stud (#15)
INSTALLATION INSTRUCTIONS:
1. Find the predrilled holes in the Circular Strap (#14) that have indentations on each
side. Thread the two Screw Studs (#15) from the indented side into the Circular Strap
(#14) then out from the raised side of the Circular Strap (#14). Thread Nuts (#12) on
the Screw Studs (#15) until tightly secured.
2. Attach the Circular Strap (#14) to the Outlet Box using the two screws (#13). The
side of the Circular strap marked “GND” should face out.
3. While holding the Canopy (#1) toward the ceiling, connect the white wire from the
fixture to the white wire from the Outlet Box (#17), and the black wire from the
fixture to the black wire from the Outlet Box (#17). Cover the two wire connections
using the two provided Wire Connectors (#16). Wrap the two wire connections with
electrical tape for a more secure connection. If your outlet box has a ground wire
(green or bare copper), connect fixture’s ground wire to it using the wire connector
(#16). Otherwise connect the copper ground from the fixture to Ground screw (#18)
on the Circular Strap (#14). Note: If you have electrical questions, consult your local
electrical code for approved grounding methods.
4. After the wires are connected, carefully tuck tem inside the outlet box. Then place
the Canopy (#1) over Screw Studs (#15) and secure against ceiling with Knurled
Knobs (#2).
5. Install Light bulbs (not included) in accordance with the fixture’s specifications. (DO
NOT EXCEED THE MAXIMUM WATTAGE RATING)
6. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn
the light switch on to activate the fixture.