INSTRUCTION MANUAL 1 Light Exterior Wall Lantern Home Depot SKU 477405 (UPC 718212230107) Home Depot SKU 495682 (UPC 718212230282) (Prairie Bronze) Page 1
Thank you for purchasing this Hampton Bay exterior wall lantern. This product has been manufactured with the highest standards of safety and quality. The finish of this lantern is weather resistant but over time will naturally weather and fade. FEATURES: 1. Easy and Economic Maintenance. 2. Weather Resistant Body. 3. ETL listed for Wet Location. 4. Easy to Install.
CAUTION: 1. Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. 2. CONSULT A QUALIFIED ELECTRICIAN IF YOU HAVE ANY ELECTRICAL QUESTIONS. 3. If you have any non-electrical questions about this fixture, please contact our Customer Service Team at 1-800-527-0998 or visit www.homedepot.com. Please reference your SKU 477405 Prairie Bronze fixture or UPC 718212230107 Prairie Bronze fixture.
PARTS INCLUDED FOR ASSEMBLY (parts are not to scale): 3 Nut (#1) 1 Finial (#2) 2 Lock Nuts (#3) ASSEMBLY INSTRUCTIONS: 1. Shut off power at the fuse box or circuit breaker box, if necessary remove old fixture and all mounting hardware from outlet box. 2. Carefully unpack your new fixture and lay out all the parts on a clear area, Take care not to lose any small parts necessary for installation. 3. Install light bulbs in accordance with the fixtures specifications.
ASSEMBLY: 4.Fixture Frame 5.Wall Plate 3.Lock Nut 6.Light Bulb 1.Nut 7.Glass Shade 2.
PARTS INCLUDED FOR INSTALLATION (parts are not to scale): 1 Ground Screw (#8) 2 Outlet Box Screws (#9) 1 Cross Bar (#11) 2 Wire Connectors (#12) 2 Mounting Screws (#10) INSTALLATION INSTRUCTIONS: 1. Screw the two Mounting Screws (#10) into the Cross Bar (#11). Mount the Cross Bar (#11) to the Outlet Box (#13) using the two provided Outlet Box Screws (#9). [Make sure the threads of the Mounting Screws (#10) are facing outside when the Cross Bar (#11) is attached to the Outlet Box (#13).] 2.
INSTALLATION: Page 7
TROUBLESHOOTING: Bulb will not light. Possible Cause 1. Bulb is burned out. 2. Power is off. 3. Faulty wire connection. 4. Faulty switch. Fuse blows or circuit breaker trips when light is turned on. Corrective Action 1. Replace light bulb. 2. Make sure power supply is on. 3. Check wiring. 4. Test or replace switch. Crossed wires or power wire Check wire connections. is grounding out. PRODUCT MAINTENANCE: 1.
