INSTRUCTION MANUAL 1 Light Exterior Chain Hung Home Depot SKU xxxxxx (UPC 718212230244) (Dark Ridge Bronze Finish) Page 1
Thank you for purchasing this Hampton Bay exterior chain hung. This product has been manufactured with the highest standards of safety and quality. The finish of this lantern is weather resistant but over time will naturally weather and fade. FEATURES: 1. Easy and Economic Maintenance. 2. Weather Resistant Body. 3. ETL listed for Damp Location. 4. Easy to Install.
CAUTION: 1. Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. 2. CONSULT A QUALIFIED ELECTRICIAN IF YOU HAVE ANY ELECTRICAL QUESTIONS. 3. If you have any non-electrical questions about this fixture, please contact our Customer Service Team at 1-877-527-0313 or visit www.homedepot.com.
PARTS INCLUDED FOR ASSEMBLY (parts are not to scale): 1 Canopy (#3) 1 Chain (#2) 1 Quick Link(#14) ASSEMBLY INSTRUCTIONS: 1. Shut off power at the fuse box or circuit breaker box, if necessary remove old fixture and all mounting hardware from outlet box. 2. Carefully unpack your new fixture and lay out all the parts on a clear area, Take care not to lose any small parts necessary for installation. 3. Install light bulbs in accordance with the fixtures specifications.
ASSEMBLY: Page 5
PARTS INCLUDED FOR INSTALLATION (parts are not to scale): 1 Ground Screw (#8) 3 Wire Connectors (#12) 2 Outlet Box Screws (#9) 1 Hex nut (#15) 1 Nipple (#10) 1 Cross Bar (#11) 1 Lock Washer (#16) INSTALLATION INSTRUCTIONS: 1. Thread Nipple (#10) into the collar loop (#6) until snug. 2. Thread other end of Nipple with Loop attached into crossbar (#11) until snug. 3. Place Lock Washer (#16) over end of Nipple protruding through crossbar and thread Hex Nut (#15) onto nipple until tight. 4.
INSTALLATION: Page 7
TROUBLESHOOTING: Bulb will not light. Possible Cause 1. Bulb is burned out. 2. Power is off. 3. Faulty wire connection. 4. Faulty switch. Fuse blows or circuit breaker trips when light is turned on. Corrective Action 1. Replace light bulb. 2. Make sure power supply is on. 3. Check wiring. 4. Test or replace switch. Crossed wires or power wire Check wire connections. is grounding out. PRODUCT MAINTENANCE: 1.
