INSTRUCTION MANUAL 1 Light Mini Pendant in Brushed Nickel Finish Home Depot SKU xxx-xxx (UPC xxxxxxxxxxxx) (Brushed Nickel Fixture) 17211E/S/F Page 1
Thank you for purchasing this Hampton Bay interior light fixture. This product has been manufactured with the highest standards of safety and quality. FEATURES: 1. Traditional 1 Light Mini Pendant in Brushed Nickel Finish. 2. Timeless Elegant Design. 3. Easy to assemble and install. QUESTIONS, PROBLEMS, MISSING PARTS： Before returning to your local Home Depot, please call our Customer Service Team at 855-HD-Hampton or visit www.homedepot.com.
CAUTION: 1. Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. 2. CONSULT A QUALIFIED ELECTRICIAN IF YOU HAVE ANY ELECTRICAL QUESTIONS. 3. If you have any non-electrical questions about this fixture, please contact our Customer Service Team at 855-HD-Hampton or visit www.homedepot.com.
PARTS INCLUDED FOR ASSEMBLY (parts are not to scale): 4 Bar (#3) 1 Light Bulb (#5) (40 watt maximum) ASSEMBLY INSTRUCTIONS: 1. Shut off power at the fuse box or circuit breaker box, if necessary remove old fixture and all mounting hardware from outlet box. 2. Carefully unpack your new fixture and lay out all the parts on a clear area, take care not lose any small parts necessary for installation. 3. Determine length desired and thread Bar (#3) to Canopy (#1) and Fixture Body (#4) to the desired length.
ASSEMBLY： 1. Canopy 2. Lock Knobs 3. Bar 4. Fixture Body 5.
PARTS INCLUDED FOR INSTALATION (parts are not to scale): 1 Ground Screw (#11) 2 Mounting Screws (#6) 2 Outlet Box Screws (#7) 3 Wire Connectors (#9) 1 Crossbar (#10) 2 Lock Knobs (#2) INSTALATION INSTRUCTIONS: 1. Attach the Crossbar (#10) to the Outlet box using Outlet Box Screws (#7) from the outlet box. The side of the Crossbar with “GND” marked on it and two convex points must face out. 2.
INSTALATION： 8. Outlet Box 9. Wire Connector Ground Wire White Wire Black Wire 10. Crossbar 11. Ground Screw 7. Outlet Box Screw 6. Mounting Screw 1. Canopy 2.
TROUBLESHOOTING: Bulb will not light. Possible Cause 1. Bulb is burned out. 2. Power is off. Corrective Action 1. Replace light bulb. 2. Make sure power supply is on. 3. Faulty wire connection. 3. Check wiring. 4. Faulty switch. 4. Test or replace switch. Fuse blows or circuit breaker Crossed wires or power wire Check wire connections. trips when light is turned on. is grounding out. PRODUCT MAINTENANCE: 1.
