Installation Guide

Page 6

PARTS INCLUDED FOR INSTALLATION (parts are not to scale):

1 Lock Collar (#11) 1 Canopy (#12) 1 Ceiling Loop with Chain (#13) 1 Quick Link (#10)

1 Hex Nut (#19) 1 Lock Washer (#18) 1 Ground Screw (#15) 2 Outlet Box Screw (#16)

1 Crossbar (#17) 3 Wire Connector (#20) 1 Nipple (#14)

INSTALLATION INSTRUCTIONS:

1. Thread Nipple (#14) into Ceiling Loop with Chain (#13) until snug.

2. Thread other end of Nipple with ceiling loop attached into crossbar (#17) until snug.

3. Place Lock Washer (#18) over end of Nipple protruding through crossbar and thread Hex

Nut (#19) onto nipple until tight.

4. Take the crossbar assembly and mount to Outlet box with Outlet box screws (#16). Tighten

screws securely with screwdriver.

5. By measuring determine correct number of links needed for proper hanging height. Use a

pair of pliers to open one end link of the chain and discard un-wanted chain. (Don’t

disregard the Quick Link linked at the end of Chain.)

Slip Canopy (#12) and Lock Collar (#11) through over the Ceiling Loop with Chain

(#13), then connect the other end of Ceiling Loop with Chain (#13) to Fixture Loop

(#1) by using Quick Link (#10).

7. Lace the fixture’s wires through the chain links and pull until taut. Feed the fixture wires

through the Lock Collar, Canopy, Ceiling Loop and Nipple, pull wire until taut.

8. Connect the ribbed wire from the fixture to the Neutral wire from the outlet box (#21) and

the smooth wire from the fixture to the hot wire from the outlet box (#21). Cover the two

wire connections using the two provided wire connectors (#20). Wrap the two wire

connections with electrical tape for a more secure connection.

If your outlet box has a

ground wire (green or bare copper), connect fixture’s ground wire to it using the wire

connector (#20). Otherwise connect the copper ground from the fixture to Ground

screw (#15) on the Crossbar (#17).

Note: If you have electrical questions, consult your

local electrical code for approved grounding methods.

9. Tuck these wire connections neatly into the ceiling outlet box and then raise the canopy all

the way to the ceiling. Raise the Lock Collar and thread onto Ceiling Loop protruding

through Canopy.

10. Install the proper Light bulbs (not included) in accordance with the fixture’s specifications.

(DO NOT EXCEED THE MAXIMUM WATTAGE RATING)

11. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the

light switch on to activate the fixture.