Installation Guide

Page 4
PARTS INCLUDED FOR ASSEMBLY (parts are not to scale):
1 Fixture Loop (#1) 1 Pine Cone (#3) 1 Finial (#5) 5 Glass Shade (#6)
5 Screw Shell (#8) 5 Metal Ring (#7) 1 Metal Leaf (#23)
ASSEMBLY INSTRUCTIONS:
1. Shut off power at the fuse box or circuit breaker box, if necessary remove old fixture
and all mounting hardware from outlet box.
2. Carefully unpack your new fixture and lay out all the parts on a clear area, Take care
not to lose any small parts necessary for installation.
3. Secure the Center Tube (#2) to nipple at the top of Housing (#4), then secure the
Fixture Loop (#1) onto the top of Center Tube (#2) and pull the wires until taut.
4. Secure the Finial (#5) to nipple at the bottom of Housing (#4).
5. Adjust the Arms (#9) to the proper position.
6. Place Glass Shade (#6) and Metal Ring (#7) over socket, secure in place with Screw
Shell (#8).
7. Secure the Pine Cone (#3) and Metal Leaf (#23) to the metal stick on the Center
Tube (#2) and put them in proper location as shown.