Installation Guide

Page 4
PARTS INCLUDED FOR ASSEMBLY (parts are not to scale):
1 Loop (#1) 1 Glass Shade (#7) 4 Long Screw (#3) 1 Poly Ring (#5)
8 Short Screw (#3)
1 Finial (#8) 1 Pipe (#6)
ASSEMBLY INSTRUCTIONS:
1. Shut off power at the fuse box or circuit breaker box, if necessary remove old fixture
and all mounting hardware from outlet box.
2. Carefully unpack your new fixture and lay out all the parts on a clear area, Take care
not to lose any small parts necessary for installation.
3. Secure Top Loop (#1) to Top Housing on Center Cluster Assembly (#2).
4. Assemble Arm (#4) to Top Housing and secure with Long Screws (#3).
5. Make Poly Ring (#5) match with the screw hole on the bottom of Arm (#4) and
secure with Short Screw (#3).
6. Thread Pipe (#6) into the end of Center Cluster Assembly (#2).
7. Slide Glass Shade (#7) upwards into Poly Ring (#5) over Pipe (#6) then tighten with
Finial (#8).