Installation Guide

7 HAMPTONBAY.COM

Please contact 1-855-HD-HAMPTON for further assistance.

Installing the canopy to the outlet

box

Installing the glass shades and light

bulbs

ƶ Raise the canopy (A) all the way up to the ceiling, and tighten

the ring (DD) onto the screw collar loop (EE) until the canopy

(A) is rmly held against the ceiling.

ƶ Unscrew the socket rings (E) from the sockets on the xture

body (D). Set the glass shades (F) onto each socket, and

secure them with the socket rings (E).

ƶ Install the light bulbs (not included) into the sockets. Use

three 60-watt maximum medium base (E26) type A bulbs.

NOTE: You can also use three 13W maximum medium

base (E26) SBCFLs (sold separately). Do not exceed the

recommended wattage.

Care and Cleaning

ƶ Do not use any cleaners with chemicals, solvents, or harsh abrasives. Use only a dry, soft cloth to dust or wipe carefully.

ƶ To clean the xture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box, and use a dry or

slightly dampened, clean cloth to wipe the exterior surface of the xture.

Troubleshooting

Problem Possible Cause Solution

The lights will not turn on. The bulb is burned out.

Replace the light bulb.

The power is off.

Ensure the power supply is turned on.

There is a faulty switch.

Test or replace the switch.

There is a faulty wire connection.

Check the wiring.

The fuse blows, or the circuit breaker

trips, when the light is turned on.

There are crossed wires, or the power

wire is grounding out.

Discontinue use of the lamp. Check the wire connections.

Contact a qualied electrician or call the Customer Care

Service Team at 1-855-HD-HAMPTON.

Installation (continued)