Installation Guide

5 HAMPTONBAY.COM

Please contact 1-877-527-0313 for further assistance.

Installation

Preparing for installation

Attaching the canopy to the outlet

box

□ Fasten the mounting bracket (AA) onto the outlet box using

two outlet box screws (BB).

□ Screw the threaded tube (II) into the mounting bracket (AA),

and secure it using the lock washer (HH) and hex nut (FF).

NOTE: This threaded tube (II) should extend long

enough to protrude through the canopy when it is

mounted. (Adjust as needed)

□ Place the canopy (A) over the threaded tube (II), and screw the

screw collar loop (EE) onto the threaded tube (II).

□ Secure the canopy (A) using the ring (DD).

Assembling the fixture body

Attaching the chain

□ Guide the fixture wire with bare copper grounding wire

through the loop (C), and screw the loop (C) onto the nipple

joint on the fixture body (E) securely.

□ Secure each arm (D) to the fixture body (E) using two knob

nuts (JJ), as shown.

NOTE: Do not twist the fixture wire.

□ Adjust the chain (B) to the desired height by spreading apart

the end link of the chain (B). Use a pair of pliers and a

screwdriver. Wrap a soft cloth around the pliers to protect the

chain’s finish.

□ Attach one end of the chain (B) to the screw collar loop (EE)

and the other end to the loop (C).