Installation Guide

Page 6

PARTS INCLUDED FOR INSTALLATION (parts are not to scale):

2 Cap Nut (#4) 2 Hex Nut (#7) 2 Outlet Box Screws (#8)

)01#( wercS dnuorG 1 )31#( srotcennoC eriW 3 )9#( partS ralucriC 1

INSTALLATION INSTRUCTIONS:

2. Attached the Circular Starp (#9) to the Outlet Box (#12) with the two Outlet Box

Screws (#8) as shown. The side of the Circular Strap (#9) marked “GND” must face out.

Thread the Mounting Screws (#6) into the pre-drilled holes of the Circular Strap (#9)

space the same distance apart as the holes on the fixture canopy. Thread the Hex Nuts (#7)

onto the Mounting Screws (#6) until tightly.

2 Mounting Screw (#6)

Connect the white wire from the fixture to the white wire from the Outlet Box (#12),

and the black wire from the fixture to the black wire from the Outlet Box (#12). Cover

the two wire connections using the two provided Wire Connectors (#13). Wrap the two

wire connections with electrical tape for a more secure connection. If your outlet box

has a ground wire (green or bare copper), connect fixture’s ground wire to it using the

wire connector (#13). Otherwise connect the copper ground from the fixture to Ground

screw (#10) on the Circular Strap (#9). Note: If you have electrical questions, consult

your local electrical code for approved grounding method.

4. Place the Fixture body (#3) over the Mounting Screws (#6) so it protrudes through the

holes on the fixture canopy. Screw the Cap Nuts (#4) onto the end of the Mounting

Screws (#6) until fixture is secured to the wall.

5. Install the proper light bulbs (not included) for your fixture. (DO NOT EXCEED THE

SPECIFIED WATTAGE!)

6. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the

light switch on to activate the fixture.