Instructions / Assembly

6
ASSEMBLY AND INSTALLATION INSTRUCTIONS:
1. Shut down the main electrical supply from the fuse box or circuit breaker in your house or building.
2. Tighten support screws (long) full turns into the inside mounting hole of mounting strip (to be fully
tightened later) secure by hex nut. This support screws (long) should extend long enough to protrude
through the canopy when it is mounted.(Adjust as needed)
3. Fasten the mounting strip onto outlet box using two outlet box screws (short).
4. Connect the wire from the fixture to the power supply wire from outlet box. Cover with wire connectors.
A. Twist together white wire from the fixture with white wire from outlet box. Cover with wire connector.
B. Twist together black wire from the fixture with black wire from outlet box. Cover with wire connector.
C. The bare copper grounding wire from the fixture must loop one turn under the head of green screw on
mounting strip before it is connected to the grounding conductor of the supply circuit.
5. Carefully position all wiring inside outlet box.
6. Place the canopy over the outlet box, let the heads of support screws (long) come through the holes of the
canopy, then tighten the cap nuts to the protruding support screws on mounting strip until the canopy is
held firmly against the ceiling.
7. Install the bulbs (not included). Use 60-watt Maximum standard type A bulbs or MAX 13W UL
LISTED CFL bulb.
8. Screw the threaded tube into the bushing located on socket assembly, Place the washer and shade through
the threaded tube and secure by tightening the finial.
9. Turn on the electrical power in your house or building to activate the semi-flush light fixture.