Instructions / Assembly

Installation (continued)

Connecting the wires

□ Strip 3/4 in. of insulation from the wire ends, and twist the

stripped ends together with pliers.

□ Connect the glossy/live wire from the fixture to the black wire

from the outlet box, and the rough/neutral wire from the

fixture to the white wire from the outlet box.

□ The bare copper grounding wire from the fixture must loop

one turn under the head of the green ground screw (BB) on

the mounting bracket (AA) before it is connected to the

grounding conductor of the supply circuit.

□ Cover the wires with wire connectors (EE). Tape the wire

connectors (EE) and wires together, and carefully position all

wires inside the outlet box.

NOTE: The glossy/live wire has the text printed on it;

the rough/neutral wire has the ridge on it.

Attaching the canopy assembly to

the outlet box

Installing the glass shades and

light bulbs

□ Place the canopy assembly (B) over the outlet box, and

ensure the heads of the support screws (AA) (long) come

through the holes of the canopy assembly (B).

□ Tighten the cap nuts (FF) onto the protruding support

screws (AA) on the mounting bracket (A) until the fixture

body is held firmly against the ceiling.

□ Unscrew the socket rings (H) from the sockets. Set the

glass shades (G) onto each socket, and secure them with

the socket rings (H).

□ Install the light bulbs (not included) into the sockets. Use

three 60-watt medium base bulbs.

NOTE: You can also use three 13w maximum SBCFL

bulbs (sold separately). Do not exceed the recommended

wattage.