Installation Guide

8.
Attaching the Glass
Shade
CAUTION - To reduce the risk of electrical
shock, disconnect the electrical supply circuit
to the fan before installing light kit.
THE GLASS IS FRAGILE, USE CARE
WHEN INSTALLING THE LIGHT KIT AND
THE GLASS SHADE.
1. Remove the bottom cover and nal from the
threaded tube.
2. Install the threaded tube onto the stem of the
light kit.
3. With the power off, insert the intermediate
bulbs into the light kit sockets. Max 60 watt
(provided).
4. Raise the glass shade up against the light kit
plate of the fan motor assembly and secure
with the bottom cover and nial removed in
step 1 (Figure 10).
Bulbs
Light Kit
Plate
Stem
Threaded
Tube
Glass
Shade
Bottom
Cover
Finial
Figure 10
TO AVOID ACCIDENTAL BURNING OF THE SKIN,
ALLOW THE BULBS TO COOL COMPLETELY
BEFORE TOUCHING OR REPLACING THE
BULBS.
OVER-LAMPING THE FAN WILL RESULT IN
THE FAN LIGHTS SHUTTING DOWN UNTIL THE
PROPER WATTAGE BULBS ARE INSTALLED.
RESET THE LIGHTS BY TURNING OFF, REPLACE
BULBS WITH THE CORRECT WATTAGE BULBS
AND TURN POWER ON.