Item # 622 472 USE AND CARE GUIDE NATURE LOG FOUNTAIN
Table of Contents Table of Contents..........................................................2 Assembly ....................................................................... 4 Safety Information.........................................................2 Operation ....................................................................... 5 Warranty.........................................................................3 Maintenance ..................................................................
Warranty If this product fails due to a defect in materials or workmanship at any time during the first one year of ownership, the manufacturer will replace it free of charge, postage-paid at their option. This warranty does not cover products which have been abused, altered, damaged, misused, cut or worn. This warranty does not cover use in commercial applications.
Assembly 1 □ □ □ 2 Connecting hose to pump outlet Connect the flexible hose (E) to the pump outlet (F). Make sure the connection is tight. Place the pump (C) in the bottom of the reservoir. □ □ Connecting the cords Connect the pump cord (G) to the transformer (B) base. Connect the LED light cord (D) to the transformer cord branch (H). H D B G 3 □ □ Filling the reservoir Use clear and clean water. Make sure the water can completely submerge the pump. The reservoir should be 75% full at minimum.
Operation 1 □ □ 2 Turning on the pump Plug the electrical cord into a power outlet and switch the pump on. After a few moments, the water starts to flow. □ Adjusting the pump flow rate Move the flow control slider (H) towards the + to increase the flow rate and move the slider towards the - to decrease the flow rate. H NOTE: Splashing can occur if the flow rate is too high or the reservoir is too full. NOTE: You must use a GFCI outlet.
Maintenance □ Disconnect the power before you service or clean the fountain. □ Regularly check that the water reservoir has enough water to cover the pump at all times. Check the water level more frequently in warm or windy weather. □ Do not allow the pump to freeze. During cold spells, remove the pump from the fountain and place it in a water-filled container in a frost-free location. DO NOT store the pump dry.
Troubleshooting CAUTION: Running the pump without enough water can damage the pump. CAUTION: Excessive weight or pressure on any of the fountain sections may cause it to fall. Keep pets, children, or anyone from sitting, leaning, or climbing on any of the fountain components. Problem The pump will not run Cause Corrective Action Faulty circuit breaker Check the circuit breaker. Faulty outlet Try another GFCI outlet. Not enough water in the fountain Check the water level in the fountain.
Retain this manual for future use.
