Instructions / Assembly

Fasten the blade assemblies (D) to the motor with motor

screws (HH) and lock washers provided. Repeat this

procedure for the remaining blade assemblies. Make sure

all motor screws (HH) are tightened securely.

Remove the three light kit screws and washers (LL) from the

side of the switch housing cover on the light kit (F) and set

them aside.

Remove the finial nut (MM), cover plate (NN), hexagon nut

(OO) flat washer (PP), and rubber washer (QQ) from the light

kit (F).

Locate the single blue wire and single white wire from the

switch housing marked “FOR LIGHT KIT CONNECTION”.

Connect the blue wire from the switch housing to the black

wire from the light kit, and the white wire from the switch

housing to the white wire from the light kit simply by joining

the connector plugs (RR) together. Be sure the push-in type

terminals snap into place.

Carefully push all wires back into the switch housing. Secure

the light kit (F) onto the switch housing using the previously-

removed light kit screws and washers (LL).