Instructions / Assembly

1-855-HD-HAMPTON

Installing the motor

Attaching the motor housing

Match the three holes at both ends of the hanger bracket (A)and

the mounting bar (I). Secure the fan assembly (B) onto the

hanger bracket (A) with the three mounting screws and washers

removed in step 2 (Hanging the fan to the hanger bracket).

Place the motor housing (C) over the motor assembly (B) and

against the ceiling, matching the four holes on the perimeter

of the hanger bracket (A). Secure the housing (C) onto the

hanger bracket (A) with the four side-mount screws (RR) and

washers provided.

Insert the blade screw (AA) through the blade holder (E) and

blade (D). Start the blade screw (AA) through the flat washer

(CC) into the hexagon nut (BB). Repeat this procedure

without tightening the screw until all three screws have been

started into the hexagon nuts (BB).

Once all three screws (AA) are attached, tighten each screw

(AA) securely starting with the center screw. Make sure the

blade (D) is straight.

Repeat these steps for the remaining blades (D) and blade

holders (E).