Installation Guide

2

Locating the Highpoint on the Floor for a Wall
Highpoint of Floor
at Wall 1
 LayoutandPlanningtheInstallation
1. Takeinventoryofthecabinetsaspertheplanororder.
2. Findthehighspotinthefloorusingalevelasshownbelow.

 

3. Measureupthewall34½”abovethehighspotanddrawalevel
lineanywherethatbasecabinetswillbeinstalled.(Thismeans
thatthislinewillmeasuregreaterthan34½”abovethefloorin
mostplacesalongthewall.)

4. Findandmarkthestuds.Thiscanbedonebytrialanderrorof
drivinganailinthewalluntilyoufindastudoruseanelectronic
studfinder.Studswillusuallybeevery16”centertocenter.

   
Locating the Highpoint on the Floor for an Adjacent Wall
Highpoint of Floor
at Wall 1
Highpoint o f Floor
at Wall 2
Locating the Highpoint on the Floor Between Two Walls
Highpoint of Floor
at Wall 1
Highpoint of Floor
at Wall 2
Step1
Step2
Step3
Placeamark34½”
upfromthehighspot
infloor