User Manual

3

取扱説明書
Upstream Downstream
CU-1
NAMES AND FUNCTIONS
❶ LOWER MANUAL
Square-front (“waterfall”-style) virtual multi-contact keys, 61
notes.
❷ PRESET KEYS
Selects the Patch or Favorite of the Lower part. 9 Preset Keys
plus Cancel, 2 Preset Keys for adjusting Drawbar settings.
❸ POWER LAMP
Indicates when the power is “ON.”
❹ SIDE PANELS
Use these decorative side panels to help secure the XK-5 Draw-
bar Keyboard on either side.
❺ SIDE BRACKET
Place the XK-5 Keyboard on top of these brackets.
❻ H-BUS FROM ORGAN JACK
Use a proprietary Hammond  cable to connect the
XK-5 Keyboard to the XLK-5.  e cable will supply both DC
power and data from/to the XK-5.
❼ H-BUS TO PEDAL JACK
Use a proprietary Hammond  cable to connect the
XLK-5 an EXP-250 Expression Pedal or an XPK-250W Pedal
Clavier.
❽ CU-1 JACK
Use to connect a CU-1 Leslie Mode Switch.
❾ CU-1 MOUNTING HOLE
 ree (3) mounting holes are provided to allow the CU-1 to be
mounted in two di erent locations.
󱀓 HOLE CAP (2pcs)
Use these to plug the screw holes on the rear of the XK-5 Key-
board (see page 5).
󱀔 KNOB BOLT (4pcs)
M6 x 15mm.
󱀕 RUBBER FOOT (4pcs)
Use these if you wish to mount the XLK-5 to an ST-XLK3
Keyboard Stand.
󱀖 TAPPING SCREW (4pcs)
ø4 x 12mm. Use these to attach the rubber feet described above
to mount the XLK-5 to an ST-XLK3 Keyboard Stand.
󱀗 H-BUS CABLE
25cm. Use with sticking  label.
󱀘 PROTECTIVE SHEET (2pcs)
Use these to protect the inside of the panels from the  aw dur-
ing attaching the XK-5.
Downstream side

❸
❹❺
❷
❼
󱀗
❻
❶
󱀓
❽
❾
󱀔
󱀕
󱀖
󱀘