User Manual

ManualsBrandsHammond ManualsElectric and Liturgical OrgansXK3C - 61-KEY MIDI / USB ORGAN WITH VIRTUAL TONEWHEELS

Setting the Parameters

MOTOR

There is no pitch-bend function on the B-3/C-3.

So some musicians turned off the power while

playing in order to get that effect.

If the B-3/C-3 is turned off, the Tone-wheel motor

gradually slows down and stops, and the amplifier

does as well. This function is to simulate that on

this model.

6. BEND - MODE (P)

It switches the function of the PITCH BEND wheel.

BENDBEND

BEND: You can slide the pitch by rotating the PITCH BEND wheel.

MOTORMOTOR

MOTOR:

You can control the TONE-WHEEL motor. The motor turns on when it is in the

center or in the neutral position, stops when you rotate it forward (toward

yourself), and accelerates when you push it back.

7. BEND - TIME (P)

This sets the time for slowing down to stop or accelerating the motor when it [= MODE(6)]

is in the MOTOR mode.

The value ranges from 0.1[s] to 5.0[s].

8. BEND - AMPLIFIER (P)

This decides whether to turn off the amplifier or not by rotating the PITCH BEND wheel

forward (toward yourself).

When the value of this parameter is “OF”, the pitch goes down and the sound gradually

fades out.

MODULATION

9. MODULATION - LESLIE (P)

Assigns the Modulation Wheel to Leslie Speed Function.

OFFOFF

OFF: Does not function.

SPEEDSPEED

SPEED:If you push back and pull foward the Modulation Wheel, the speed of Leslie

effect changes fast to slow continuously.

ASTAST

AST: If you push back the Modulation Wheel, it is FAST mode, and if you pull it

forward, SLOW.

NOTE: The parameters by the names with (P) on the end are Preset Parameters, and are

recorded to each Combination Preset. (G) is for “Global”. These parameters will be

recorded when set, and are common in each Combination Preset.

HOW PITCH BEND MODE WORKS

BEND: The pitch immediately rises.

MOTOR: The pitch gradually rises up to the set

point.

BEND: The pitch immediately comes to normal.

MOTOR: The pitch gradually comes to normal.

BEND: The pitch immediately falls.

MOTOR: The pitch gradually falls down to the set

point.