User Manual

*#1 :-%Owner’s Manual

CONTROL

In this mode, you can control the setting relating to each

controller.

You may change the roles of several knobs and switches

mounted on this keyboard. Also, on the rear panel are two

jacks for connecting the Foot-switch and the Expression

Pedal. You must choose either of them in this mode.

To locate this mode:

1. Touch the [MENU/EXIT] button and display the MENU and

select PAGE A by the [PAGE] button, and then touch the [4]

CONTROL button.

2. Or, you may touch the [CONTROL] button (in default).

DRAWBAR

1. DRAWBAR - CONTROL MODE (G)

This is for setting how the right and left Drawbars function, when [A<] or [B] of the

Preset key is selected.

UPPER/LUPPER/L

UPPER/L

OWEROWER

OWER:

The left Drawbar controls the UPPER and the right one the LOWER Part re-

spectively.

/B/B

/B:

While [A<] is ON, the right Drawbar controls the UPPER Part and the left

Drawbar does not operate. Also, while [B] is ON, the right Drawbar does not

operate but the left Drawbar controls the UPPER Part. While [A<] or [B] is

ON, you can not operate the Drawbar Registration of the LOWER Part.

PITCH BEND

2. BEND - L&U DOWN (P)

3. BEND - L&U UP (P)

4. BEND - PEDAL DOWN (P)

5. BEND - PEDAL UP (P)

These are for setting the changing range of the PITCH-BEND WHEEL by the semi-tone.

Both the LOWER and the UPPER Parts change at the same time, as they use the same

Tone-Wheels.

The setting range is 0 - 12 for up, 0 - 24 for down.

2 3 4 5 6 7 8

10 11 12

14 15 11

17 18 19

22 23