User Manual
*#1 :.-Owner’s Manual
4
HOW TO ASSEMBLE
Operate carefully to avoid pinching your fingers or dropping anything on your feet.
Use a Hammond ST-XLK3 or any other stable stand with 4 legs. Do not use any
singe-column type or X-frame type stand.
2.
3.
4.
Mount the XLK-3 on the keyboard stand.
At this time, make sure the center of the stand
comes to the center of the XLK-3.
Fit the rubber feet of XLK-3 to the holes of
the keyboard stand if it has that.
Otherwise, or, if it is not stable, there is a risk
of turning over.
There are two dowels on each side
of the XLK-3 (total 4 dowels).
Carefully mount the XK-3/3C on
the XLK-3 so the dowels fit into the
4 holes on the bottom of the XK-3/
3C.
It looks like this after perfectly
assembled.
To disassemble, reverse the above
steps.
SIDE VIEW
See the illustration on the next page.
Pass the cables for connection through the
opening on the bottom of the XLK-3.
1.