Assembly Instructions

Included Components
Assembly Instructions
A. Hardware Packet Y with Instructions
B. Parallel Glass Panels or Blown Glass
C. Canopy
D. Braided Fabric Cord
E. Cord grip (attached to canopy)
Step 5: Make Wire Connections to the Driver. Braided fabric
cord must be wired to the Driver, Black to Black and White to
Red. Make wire connections from driver to source power.
NOTE: The Grey and Purple wires are used for optional
0-10V dimming. If not applicable, cap the wires.
1. Allen Key (provided)
2. Philips screw driver (not provided)
3. Wire cutters/strippers (not provided)
4. Measuring tape (not provided)
Required Tools
Step 3: Feed the braided fabric cord into the canopy until the
desired amount of cord is left between the canopy and light
body. Take into account that a minimum of 6” of cord will be
required for connecting the wiring in the J-box.
Step 4: Use the measuring tape to be sure that all of your light
body is hanging the proper distance from the canopy. Tighten
the cord grip using a flat blade screw driver. The cord grip is on
the face of the canopy.
Canopy
Braided Fabric Cord
Glass
Step 6: Mount the canopy to the ceiling using the provided
Mounting Instructions. Tape Driver to top side of Universal so
that the Driver will sit inside of the j-box.
Step 1: TURN OFF POWER TO JUNCTION BOX TO BE
USED FOR INSTALLATION.
Step 2: Mount LED driver into J-Box. Make 120 VAC
connections from the power source to the driver using the Black
and White wires. Mount the driver to the top of the universal
plate provided in the mounting packet using the double sided
tape pre-attached to the driver. Then affix the universal pate to
the J-Box using the 1.5” L #8-32 screws provided in the
mounting pack. The Black, Red, Grey, and Purple leads should
not be connected at this point.
LED Driver
(Mounts in J-Box)
WARNING: Failure to use the LED driver to power
your pendant will permanently damage your product
making it unusable
J-Box
LED Driver
Universal plate
1.5” L #8-32 Screws
Double sided tape
Step 7: Attach glass to LED pendant housing
Gem, Hedra, Rock Crystal, or Aalto Pendant:
Use #4-40 flat head screws provided to attach glass
to pendant housing.
Gem
Aalto
Rock
Crystal
Hedra
Parallel Glass Pendent:
Install glass panels by
unscrewing the cylinder knobs until glass can be slid
into housing.
Note that the cylinder knobs do not have to be fully
removed from the fixture to install glass panels.
Tighten the cylinder knobs, ensuring that the all
Ledgestone Pendant:
Use #8-32 nylon tip
set screws to retain
blown glass
Ledgestone
Blossom Pendant:
Screw glass
element into
threaded pendant
housing
Blossom
Glacier
Glacier Pendant:
Hang from nylon
mounts using
groove in glass.
Slide exterior over
then tighten finial
until snug