Assembly Instructions

Included Components
Assembly Instructions
Step 5: Attach glass to LED pendant housing.
Gem, Hedra, Rock Crystal, or Aalto Pendant:
Use #4-40 flat head screws provided to attach glass to pendant
housing.
A. Hardware Packet W, with Instructions
B. Parallel Glass Panels (QTY: 6) or Blown Glass (QTY:3)
C. Canopy
D. Braided Fabric Cord (QTY:3)
E. Cord grip (QTY:3 — Attached to canopy)
F. Flat Cap
G. Cylinder Knobs with All thread (QTY: 12)
or Set Screws
Step 3: Make Wire Connections to the Driver. Braided fabric
cord must be wired to the Driver, Black to Black and White to
Red. To wire in series make the following connections.
Driver, Red Lead—LED 1, White Lead
LED 1, Black Lead—LED 2, White Lead
LED 2, Black Lead—LED 3, White Lead
LED 3, Black Lead—Driver, Black Lead
WARNING
The LED’s must be wired in series to work properly.
1. Philips screw driver (not provided)
2. Wire cutters/strippers (not provided)
3. Measuring tape (not provided)
Required Tools
Step 1: Feed the
braided fabric cord
into the canopy until
the desired amount of
cord is left between
the canopy and light
body. Take into
account that a
minimum of 6” of
cord will be required
for connecting the
Step 2: Use the measuring tape to be sure that all of your light
body is hanging the proper distance from the canopy. Tighten
the cord grip using a flat blade screw driver. The cord grip is on
the face of the canopy. DO NOT OVER TIGHTEN. THIS MAY
DAMAGE THE FIXTURE.
Step 4: Mount the canopy to the ceiling using the provided
Mounting Instructions.
Canopy
Canopy
Braided
Fabric
Cord
Blown
Glass
(Gem shown)
Braided
Fabric
Cord
Parallel
Glass
Panel
Parallel
If Parallel Glass Pendent:
Install glass panels by
unscrewing the cylinder knobs until glass can be
slid into housing.
Note that the cylinder knobs do not have to be fully
removed from the fixture to install glass panels.
Tighten the cylinder knobs, ensuring that the all
thread passes through the glass panels.
Gem
Hedra
Rock Crystal
Aalto
Step 5: Attach glass to LED pendant housing.
Gem, Hedra, Rock Crystal, or Aalto Pendant:
Use #4-40 flat head screws provided to attach glass to pendant
housing.
Ledgestone Pendant:
Use #8-32 nylon tip set screws to
retain blown glass
Legestone
Driver
Glacier Pendant:
Slide glass along nylon mounts using groove in
glass. Gently lower pendant housing to meet
glass. Tighten finial onto IP until snug.
Glacier Blossom
Blossom Pendant:
Screw glass
element into
threaded pendant
housing