CR20 S Air rifle cal. .177 (4.5 mm) Read this owneR’s Manual coMpletely. this airgun is not a toy. treat it with the same respect you would a firearm. always carefully follow the safety instructions found in this owner’s manual and keep this manual in a safe place for future use. wArning: not a toy. this aiRGun is desiGned FoR use By eXpeRienced shooteRs 18 yeaRs oF aGe oR oldeR and is intended FoR Match coMpetition oR taRGet RanGe use. this Gun does not haVe a Mechanical saFety deVice.
COnTEnT En SAFE HAnDLing OF gUnS learn how to handle your gun in a safe and proper manner. Remember that according to the basic rules of safety, touching a gun is the same as handling it. safety instructions care • • • • • • • • • • • • designation of parts • • • • • Always keep the muzzle pointed in a safe direction. Always handle any gun as if it were loaded. Always keep your finger off the trigger and out of the trigger guard until ready to shoot.
En SAFETY inSTrUCTiOnS wArning: this aiR RiFle can cause seRious inJuRy oR death. Read and Follow the instRuctions caReFully. do not load a pRoJectile into the aiR RiFle until you aRe Ready to shoot. iF you do load a pRoJectile and then decIde NOT TO ShOOT, ReMOve IT eITheR MANUAlly OR By ShOOTINg The AIRgUN AT A SAFe TARgeT. AccIdeNTS hAPPeN FAST, PleASe hANdle The aiRGun saFely. CAUTiOn For your own safety and the safety of others, carefully read these instructions before using this airgun.
En CArE PrObLEmS oils that contain acid or resin can damage the seals and possibly the air rifle finish. trigger not properly adjusted PrObLEmS CAUTiOn dirt in barrel Before any care, cleaning or maintenance, always be sure your air rifle is unloaded. Keep pointed in a safe direction. it is important to perform rountine inspections and maintain your air rifle properly.
En DESignATiOn OF PArTS Muzzle brake Rifle scope cocking lever cheek piece spacer CAUTiOn: PinCH POinT: AVOiD COnTACT wiTH mOVing PArTS. Breech Muzzle co2 cartridge Bipod picatinny rail trigger Grip stock stock weight Butt plate 5 manual.indd 5 18.02.
En HAnDLing THE CO2 CArTriDgE note: To ensure that your gun works properly, please use only Walther accessories. insert the co2 cartridge into the fore-end with the opening first and screw it tight (clockwise). the rifle is now under pressure. To test whether the cylinder has been screwed in correctly, make sure the gun is not loaded and shoot in a safe direction. If the gun doesn’t fire, check the items under “problems”. wArning: use only 88 g co2 capsules.
En LOADing THE gUn CAUTiOn CAUTiOn Always make sure that the muzzle points in a safe direction. Use only .177 caliber (4,5 mm) pellets. do not attempt to reuse pellets that have been fired or are deformed. do not us buck shot, darts, ball bearings, or other foreign objects because they can cause injury to you or someone else or may damage and/or jam the airgun. .177 (4.5 mm) wArning: Be suRe the aiRGun is always pointed in a saFe diRection.
En ADJUSTing THE TriggEr CAUTiOn wArning: the tRiGGeR FoRce is capaBle oF adJustMent Below 3-lB and when Before performing any adjustment, assembly, care or cleaning work, keep the gun pointed in a safe direction, and always check the gun to be sure it is unloaded, the air cylinder is removed, and the barrel is free of pellets and foreign matter. Always wear protective eyewear. adJusted Below 3 lB. the Gun could FiRe when dRopped.
STOCK ADJUSTmEnT JAm CAUTiOn shooting with insufficient pressure can cause a pellet to lodge in the barrel. HAnD gUArD press the button a to release the hand guard b En and remove it from the Picatinny rail. insert filled co2 cartridge. close cocking lever and shoot without a pellet. the blocked pellet will fire. If this procedure fails to resolve the problem, remove air cylinder and fire the gun in a SAFe direction until is is empty of air, then push the pellet out backwards using a cleaning rod.
En STOCK ADJUSTmEnT PiCATinnY rAiL To adjust the Picatinny rail c lengthways, loosen the screws d d . bUTT PLATE loosen screws f , adjust the height of the butt plate g and retighten the screws. use the spacers h to adjust the length of the stock. (extra screws included for additional spacers.) d f f g h the screw e is for mounting/removing the bipod.
wArrAnTY nOTES En wArrAnTY 1 YEAr LimiTED wArrAnTY this product is warranted to the retail consumer for 1 year from date of purchase against defects in material and workmanship and is not transferable. wHAT iS COVErED Replacement parts and labor. wHAT iS nOT COVErED Shipping charges to Umarex USA for defective product and damages caused by abuse or failure to perform normal maintenance as well as any other expense. consequential damages, or incidental expenses, including damage to property.
mADE in gErmAnY 0.19 lbs .177 (4.5 mm) 10.6 lbs Carl wALTHEr gmbH - Sportwaffen wArning: do not BRandish oR display this aiRGun in puBlic – it May conFuse people and May Be a cRiMe. police and otheRs May thinK it is a FiReaRM. do not chanGe the coloRation and MaRKinGs to MaKe it looK MoRe liKe a FiReaRM. that is danGeRous and May Be a cRiMe. 19.7 in. min. 43 in. www.UmarexUSA.com 7700 Chad Colley boulevard Fort Smith, Ar 72916 Phone: 479-646-4210 8.466.90.01 | 02/2011 sin gle shot max. 45 in.
