Owner's Manual

- Activate the safety (see chap. 2).
- Pull back the bolt lever of the lock and the retainer lever (see the sequence in illustration 5.a).
- Remove the rotary magazine from the air rifle (illustration 5.b).
- Load the rotary magazine by inserting pellets in the holes (illustration 4.a).
The pellets are held in place by an o-ring that traps them.
- Never shoot a used pellet. It might damage the rotary magazine and the barrel.
- Your new air rifle performs with all the pellets described in the
accessories section. Pellets with a maximum total length of 10 mm may be loaded.
4. Loading the rotary magazine
- Activate the safety (see chap. 2).
- Pull back the bolt lever of the lock and the retainer lever
(see the sequence in illustration 5.a).
THE BOLT LEVER MUST BE IN THE REAR POSITION.
- Place the rotary magazine in the air rifle (illustration 5.b).
- Push the retainer lever.
- Push the lever of the lock forward and lower it.
WARNING: A pellet is automatically loaded in the barrel
during the locking process.
5.1 Loading the rifle
1.
2.
3.
Illustration 5.a
Illustration 5.b
Illustration 4.a
Do not use steel pellets (or BBs), darts or other unsuitable ammunition. Use only
lead pellets of the caliber which matches your airgun.
WARNING:
Do not place your hand or fingers over the muzzle. Always make sure your air rifle
is pointing in a SAFE DIRECTION, and keep your finger away from the trigger. Failure to follow these war-
nings may cause serious injury or death.
WARNING: